TOHATSU MFS 6C, Service Manual

Page: 197 / 260

9
9-3 4st 4/5/6 2011
YES
YES
Good?
Check compression pressure.
NO
Check fuel system.
NO
YES
Check spark plug.
YES
Replace stop switch.
Check igniter and/or
plug cap.
Use spark tester to check
ignition sparks.
Normal ?
Check electrical conductivity of
stop switch.
(with lock plate attached)
NO
NO
To next page
Normal ?
Clean spark plug
and adjust gap,
or replace with new one.
Out of specified
range?
Before working on the outboard motor, check the hull, rigging, installation of outboard motor, fuel level, and
wire connections. For mechanical troubleshooting, refer to relevant troubleshooting section in this chapter.
For checking and servicing outboard motor, refer to service procedures described in this manual to perform
the work safely.
2. Power Unit
• Inspection of Ignition System, Fuel System and Compression Pressure
Trouble 1 Engine will not start or is a little hard to start. (Recoil starter operates normally.)
• When testing, put electrode cap assuredly to prevent
direct contact with spark tester wiring and leak of
electrical current.
• Keep flammable gas, fuel and oil away from tester to
prevent them from catching sparks.
WARNING
MFS4-5-6̲E̲ch09̲110422.qxd 11.4.22 7:00 PM ページ 3