Tobii X1 Light User Manual
25
If your VESA mounting screw holes are recessed on your monitor or if the back of
the monitor is curved, use the short spacers and the longer screws supplied in the
Alternative Mounting Kit.
•
Mount the spacers between the screw holes on the monitor and the VESA
mounting bracket to fill out the gap made by the recession or compensate for
the distance differences caused by the curvation..
•
Use the longer screws to mount the bracket to the monitor.
Use only the supplied screws to mount the Tobii X1 Light Eye Tracker to the VESA
mount of the appropriate monitor type (only use the longer screws from the Alternative
Mounting Kit if you are also using the spacers on a recessed VESA; without the
spacers you could possibly screw in the screws too far causing damage to the
monitor).
4.4.1
The mounting process
1. Slide the mounting bracket onto the screen from
the side and fasten the screws through the holes on
the mounting bracket and in the VESA mounting
screw holes at the back of the monitor.
2. When fastening the mounting bracket to the
VESA mount of your monitor do not overtighten
the screws. Tighten until you encounter resistance.
Overtightening may increase risk for breakage and
will not improve functionality. First, screw one screw in
lightly, then a second, lightly, following an X formation.
Tighten the third screw lightly, then the fourth, also
following an X formation. Then, finish tightening them
all in the same pattern.
Chapter 4
Assembling the Tobii X1 Light Eye Tracker
