7
11. AUDIO LEVEL ADJUSTMENT (SENSITIVITY CONTROL)
To change the factory-preset level, follow the procedures below.
Step 1.
Holding the microphone body, open the rubber cap as
illustrated.
Step 2.
Switch on the power of the tuner and microphone.
Step 3.
Adjust the audio level control using the supplied
screwdriver. The microphone sensitivity increases as the
control is rotated clockwise, and decreases as rotated
counterclockwise.
Step 4.
Adjust the corresponding tuner's volume control so that
its knob points to the 2 o'clock position. If the tuner's AF
peak lamp remains lit, readjust the microphone's audio level control to the position that causes the
indicator to flash when the tuner output level reaches its peak. The AF peak lamp lights when the
output level reaches the point of about 3 dB below the clipping level.
Note
The AF peak lamp operates in response to the volume control position.
However, the AF level lamp on the LCD (on the WT-5800/5805) indicates the level regardless of the
volume control setting.
Step 5.
Replace the battery cover.
12. NEW EMPHASIS CIRCUIT ON/OFF SWITCH
The WM-5320 series incorporates an improved
new Emphasis circuit that further suppresses
noise.
The Emphasis circuit can be switched to the new
circuit (pre-compressor Emphasis) by setting the
New Emphasis circuit ON/OFF switch to ON (H
position), and to the conventional circuit (post-
compressor Emphasis) by setting the switch to
OFF (L position).
When using the WM-5320 series with the switch
set to ON, also reset the WT-5800 series tuner to
a new circuit by means of the optional RW-4800
ROM Writer. So, further noise suppressed and
clearer sound can be assured.
The WM-5320 series is compatible with the WT-
4800 series turners when shipped from the
factory (New Emphasis circuit ON/OFF switch:
OFF). Once the switch is set to ON, however, no
more compatibility is ensured.
The table below shows the compatibility between
the Wireless Microphones and Tuners.
New Emphasis circuit
ON/OFF switch
H: ON*, L: OFF
Channel setting switch
Remove the battery cover.
* Enables further noise suppression
(Valid only for WT-5800 series
Wireless Tuners)
WM-5320/5320A/5320H
New Emphasis circuit
ON/OFF switch: ON (H)
WT-5800 series
Wireless Tuners
Wireless Microphones
WT-4800 series
Pre-compressor
(New Emphasis circuit)
Post-compressor
(Conventional Emphasis circuit)
New Emphasis circuit
ON/OFF switch: OFF (L)
: Compatible
[Compatibility table]
1
3
2
Audio level control
Power ON/OFF
switch
