6. BATTERY INSERTION
Step 1.
Turn off the power switch.
Step 2.
Hold the microphone body and rotate the microphone
grip counterclockwise to remove it.
Step 3.
Insert an AA battery according to (+) and (–)
indications on the battery compartment.
Step 4.
Replace the microphone grip by sliding and rotating it
clockwise.
Battery replacement
• A brand-new AA alkaline battery will continuously operate the unit for
about 10 hours.
• When the battery capacity becomes low, the green LED of the
Power/Battery lamps starts to dim, while the red LED to light.
When only the red LED lights, replace the battery with a new one. In this
condition, the unit transmits the remaining battery capacity information to
the tuner, causing the tuner's BATT indicator to light.
2
3
Green LED
Red LED
7. CHANNEL NUMBER SETTING
Step 1.
Switch off the power. Rotate the microphone grip
counterclockwise to remove it.
Step 2.
Using the supplied screwdriver, set the Channel
selector switch pointer to the desired channel number.
Step 3.
Replace the microphone grip.
Note:
Make sure that the wireless microphone is identical to
the wireless tuner in the channel number. Should the
microphone's setting differ from that of the tuner, the
tuner does not receive the microphone signal.
BANK
CHANNEL
4
3
2
1
4
5
6
7 8 9 A
B
C
D
E
F
0
3
2
1
Channel selector switch
9. OPERATIONAL HINTS
• The microphone's service distance is 3 – 120 m. When the microphone user moves in a facility, signal
dropouts (momentary losses of signal reception) may be encountered. These dropouts are caused by the
building's architectural designs or materials which block the travel of or reflect the radio signal. If this occurs,
the user needs to change locations for better signal reception.
• The proper operation of your wireless system may be interfered with by other system operating on the same
frequency. In such cases, change the operating frequency of your system. (As to dealing with the
interference, refer to the operating instructions of the wireless tuner.)
• Should you have any questions regarding the use or availability of TOA wireless products, please contact
your local TOA dealer.
8. OPERATION
Step 1.
Confirm that the wireless microphone and the wireless tuner are identical in the channel number. If
not identical, turn the power ON/OFF switch to the OFF position, then set the channel number to the
same channel number as the tuner.
Step 2.
Turn the Power ON/OFF switch to the ON position. Then, confirm the green LED of the Power/Battery
lamps will light.
Step 3.
Turn the Power ON/OFF switch to the OFF position after use.
