Toa NX-100, Installation Setup Manual

Page: 99 / 114

5-11
Chapter 5: OPERATION SETTINGS (NX-100 OPERATION PROGRAM)
Step 2. Click off the checkbox ticks in the Registration Contents List for Selection buttons not to be used on
the operation screen.
Buttons not marked with a tick are not displayed on the operation screen.
Step 3. Click on the Selection buttons (the No. or Indication Name area) to be edited in the Registration
Contents List.
The contents are displayed in the Edit area.
Step 4. Enter the Indication name in the Edit area.
Tip
There is no limit to the number of characters that can be entered, however the maximum number of
characters that can be displayed on the operation screen buttons for the screen size at startup is 16.
Because the number of displayed characters increases as the display screen increases in size, set
the number of characters to correspond to the screen size to be used.
Step 5. Check the broadcast pattern to be activated in the Broadcast pattern list.
Tips
• The Broadcast pattern list displays all patterns that have been programmed into all NX-100 and NX-
100S units in the system, including the NX-100 and NX-100S units added in the unit setting
procedure (
p. 5-6 ).
• Only one broadcast pattern at a time can be selected.
• To clear the setting contents of the selected NX-100 or NX-100S broadcast pattern, press the
leftmost Clear button in the Edit area.
Step 6. Check the contact output to be activated in the Contact output list.
The contact channel number to be output can be selected.
(Setting screen example)
Broadcast pattern list
Contact output list