5
5. CHARGING
Avoid charging microphones installed with rechargeable batteries
other than the dedicated IR-200BT battery.
Charging any other than the specified battery could result in fire or
personal injury due to battery rupture.
CAUTION
Notes
• Use the charger in locations where the ambient temperature range is between 0 and 40 ºC (32 to 104 ºF).
• Charge the IR-200BT battery before using it.
• If an infrared wireless microphone containing an IR-200BT battery has been stored for a long period of time,
it is recommended that the microphone be charged before use.
• Avoid using the charger in locations subject to strong vibrations, as the resulting poor electrical contact may
prevent correct charging.
• Do not frequently insert and remove the microphone from the charger during charging, as this could reduce
the number of times that the IR-200BT can be effectively charged and discharged.
• Rechargeable batteries are consumables and do not last indefinitely. If the battery operating time becomes
extremely short even when it has been fully charged, the battery has reached the end of its life and must be
replaced. Be sure to replace the battery with one designated for use with the microphone (IR-200BT).
Tip:
Under normal use conditions, the battery can cycle through approximately 500 charges and discharges,
after which it will usually need to be replaced.
Charger
Supplied power cord
Power switch
Power indicator
Full-charge
indicator
Charging indicator
IR-200M (optional)
Mounting adapter
(pre-installed)
Power switch
IR-300M (optional)
Power input terminal
AC adapter plug
Bottom view of the charger
Cord
To AC wall outlet
Supplied AC adapter
1
1
2
3 , 6
4
5
Handling the power cord
Step 1.
Connect the power cord to the AC adapter, then connect the AC adapter to the charger.
Once connected, push the cord into the slot in the charger's bottom surface to prevent the AC adapter
plug from accidentally slipping out of place. (Refer to "Handling the power cord" in the figure above.)
Step 2.
Insert the AC power plug into an AC wall outlet.
Step 3.
Set the charger's power switch to ON.
Confirm that the power indicator is lit.
