TMQ Bosun-AP9, Operation And Installation Manual

Page: 42 / 63

TMQ Bosun - AP9 Rev1 (935) Page 42 16/06/2003
NOTE: THE RUDDER LIMITS ARE FACTORY SET TO
APPROXIMATELY 25 DEGREES. IF THE RUDDER
FEEDBACK HAS BEEN INSTALLED CORRECTLY,
THE P_L AND S_L SYMBOLS SHOULD DISPLAY
WHEN THE RUDDER IS MOVED PORT OR
STARBOARD BY 25 DEGREES.
Setting Rudder Limit
1. Select Standby mode
2. Enter "905 " and press and hold GOTO then Auto, Standby or
Power , only the standby light will be on
The display will indicate between 0 and 256 this is
representative of rudder position where 128 is centre, 256 is
fully port and 0 is fully starboard.
3. Set the rudder to the required Port position and press Port Arrow
Button
4. Set the rudder to the required Starboard position and press Stbd
Arrow Button
5. To store the Data press " GOTO "