STEP 15
7
The final steps are attaching the Rollover Straps and Lock
Down Straps.
Lock Straps
Rollover Straps
Footman
Loops
Footman
Loop
Footman
Loops
Footman
Loops
Pull Straps
Slides
Slide
“D” Rings
Guide Tracks
STRAP PLACEMENT
NOTE
: The “D” Rings, Pull Straps and Slide Handles are
attached at the factory. Also, one end of the Rollover Straps is
attached to the bottom of the screen.
Pull the screen down to
release the 2 Rollover Straps.
A Slide is attached to each
strap. Make sure the straps
are laying flat and not twisted.
Feed the strap through the Footman Loop
that has been pre-attached to the Guide
Track. Then take the strap back through
the slide as shown in the illustration to the
right. Adjust the strap so it is taut when the
door is in the open position.
The purpose for Lock Straps is to hold the
screen in the down position. so the bottom
bar is touching the floor.
Once the Rollover Straps are set, pull the screen to the down position. Take the short Lock Straps with the Snap
Hooks on one end and snap the hook into the “D” Ring. Take the other end of the strap and pull it at a diagonal
so the Strap Grommet is centered on the front of the Guide Track. Mark the hole.
IMPORTANT
:
Place the
screen in the open position.
Drill the Pilot Hole for the Tab Weld Nut (supplied). Next, place the screen in the
down position. Finally, with the Weld Nut on the inside of the Guide Track, secure the strap with the Bolt through
the Strap Rivet.
Lock
Strap
Snap
Hook
“D”
Ring
Bolt
Tab
Weld
Nut
Pilot Hole
Strap
Grommet
