6
STEP 12
Cotter
Pin
Bottom Edge
of Screen
facing down
Once the shaft is in both cradles, place a Cotter Pin
through the square shaft and cradle to secure it (left side).
Square
Cradle
Round
Cradle
The Bottom Edge of the Screen facing down.
Then carefully cut the Roll Ties without
cutting the screen. Slip the bottom
edge of the screen into the Guide
Tracks. Place the leading edge in front
of the Rubber Gasket to create a seal.
With the Screen Roller Drum in place,
remove the Spring Locking Clip.
Bottom Edge
of Screen
Rubber
Gasket
Roll Ties
Spring Locking
Clip
STEP 13
Reposition the assembly in the
doorway opening and fasten it
securely against the jambs
with lag screws and washers.
After all adjustments are made the the Rear Spreader Plate
can be attached. It is fastened to the back (exterior) of the
Guide Tracks. Use 4 self-tapping screws.
Rear Vinyl Cover
1. Rear Vinyl Cover will attach behind
the screen barrel when standing inside the
building looking out.
2. Mount aluminum angle to header and
then attach vinyl flap using the hook/loop
provided.
3. If you ordered the Aluminum Rear Spreader
upgrade, then you will only need the 4 tek screws
to fasten the Aluminum Spreader to the back side
of the guide tracks.
Check the door movement. If the spring
needs more tension, follow the procedure
on page 8, entitled “ADDING TENSION
TO THE SPRING.”
STEP 14
Exterior of
Doorway
Opening
Rear Spreader Plate
Guide
Track
Guide
Track
Self-Tapping
Screws
Self-Tapping
Screws
Screen
Barrel
Screen
Door Jamb
Aluminum Angle
Vinyl Flap
(attach to angle
with
hook and loop
(OUTSIDE
OF THE
BUILDING)
SIDE VIEW OF
SCREEN BARREL & DOOR OPENING
