TMG TMG-GSB30, Product Manual

Page: 7 / 35

6. Attach the wire harness for heated handle control to the
harness coming off of the engine.
Attaching the Shift Lever Handles
1. Thread the shift lever handles on to the shift lever rods, one for the speed shift and one for the
discharge height control.
Attaching the Discharge Chute
1. Attach the discharge chute to the snow blower by placing
it on the chute seat on the snow blower on top of the plastic
friction ring. Position the flange keeper beneath the chute
seat lip. Align the two holes in the chute and two holes in the
flange keeper and secure with two bolts from the top side
(see Figure 7). Repeat in three locations to attach the
discharge chute to the snow blower.
2. Attach the chute crank bracket aligning the chute notches
with the spiral end of the chute directional control assembly
using the two hex bolts, flat washers and nylon lock nuts from
the hardware kit (see Figure 8). Lubricate both ends of the
chute directional control crank with petroleum jelly, paraffin
wax, or light machine oil.
Attaching the Chute Height Control Cable
1. Attach the chute height control cable to the bracket
underneath the control panel. Route the cable through the
notch in the bottom bracket and tighten the two hex nuts
on the top and bottom of the bracket. Then attach the
cable end with the screw eye to the post on the upper
bracket and secure with a R-clip.
NOTE: It will be easiest to attach the screw eye end of the cable to the bracket post when the chute
height control knob is in the highest position (pulled towards the operator).
Adjusting the Skid Shoes
1. Position the skid shoes based on surface conditions.
Adjust upward for hard-packed snow. Adjust downward
when operating on gravel or crushed rock surfaces.
Loosen the two hex nuts that retain the skid shoe in
place and move up or down as desired, then retighten the
lock nuts (see Figure 9). Repeat for the opposite side of the
snow blower.
Fig 6
Chute
Direction
Control
Handle
Control
Cable
Skid Shoe
Hex Nut
(2pcs)
Fig 9
Discharge
Chute
Chute
Seat Flange
Keeper
Fig 7
Discharge
Chute
Chute
Directional Control
Fig 8
www.tmgindustrial.com 07/35 Toll Free:1-877-761-2819