(2) Adjusting the hose bumper
(3) Removing and positioning guide arm
3.TO INSTALL THE HOSE
1.Route the hose through the guide arm roller sand opening of the spool. Apply thread tape or sealant to hose threads.
2.Screw hose fitting into threaded fitting on swivel. Tighten connection with a wrench on fitting. Install stopper on working
end of hose if required.
3.Disengage latch paw land allow hose tore tract.
4.Replacing the swivel
1.If the swivel leak,replace the O-ring or seal (#19) and washer (#18) by removing the lock washer (#21) and the part of the
swivel shift.
2.If the balls (#24) wear out, replace by removing the lock washer(#21).
3.Replace the new seal by clipping the lock washer (#21). Replace the part of the swivel shift by clipping the lock washer
(#21).
WWW.TMGINDUSTRIAL.COM
P15/20
Toll Free:1-877-761-2819
