9. Use fluids and solvents that are compatible with the equipment wetted parts. Refer to the Technical Data section of all
equipment manuals. Read the fluid and solvent manufacturer's warnings.
10. Do not move or lift the equipment when the control valve is in use.
11. The operation environment must be fireproof, safety electric use and other security assured.
12. Do not point the dispensing valve at anyone or at any part of the body.
13. Do not stop or deflect leaks with your hand, body, glove or rag.
14. Do not use oil that has been polluted.
15. Do not put your hand or fingers over the fitting coupler
16. Follow the Pressure Relief Procedure in the OPERATION INSTRUCTIONS section if the grease fitting coupler clogs and
before you clean or service this equipment.
17. Before each use, make sure that all connections are properly installed. Tighten all fluid connections before operating the
equipment.
Check the hoses, tubes, and couplings daily. Replace worn or damaged parts immediately. Do not repair high-pressure
couplings. You must replace the entire hose.
NOTE: Use oil resistant pipe sealant or Teflon Tape on all fitting threads.
1. OPERATION
1.Check reel for correct operation by slowly pulling out the hose. A “clicking” noise will be heard every half revolution of the
drum.
2.To latch the reel, pull out the hose and allow it to retract after hearing the first second or third “click”.
2. ADJUSTMENTS FOR HOSE REEL
(1) Adjusting spring tension
If necessary, adjust spring tension on reel by adding or removing wraps of hose from spool, one wrap at a time,
until desired tension is obtained.
1. Pull out the hose until the latch pawl is engaged.
2. Loosen the stopper (part#46 of hose reel), then add wrap sorde crease the wraps. Add wraps to increase
tension. Remove wraps to decrease tension.
3. Tighten the stopper (part#46 of hosereel),and adjust stopper position if necessary.
WARNING:
If this is a new installation, or if the oil in the lines is contaminated, flush the lines before you install
the kit. No impurities or contaminant are allowed to enter the kit.
WARNING:
To reduce the risk of serious injury, the pressure release should be concerned. Please follow the
Pressure Relief Procedure in OPERATION INSTRUCTIONS section for the release process.
WARNING:
To reduce the risk of static sparking, effectively ground all of this equipment.
WARNING:
Follow the instructions in PRESSURE RELIEF PROCEDURE before each operation.
CAUTION:
Do not exceed the winding mechanism’s spring capacity when adding wraps of hose. Add just enough
wraps of hose to achieve the desired tension. The winding mechanism will be damaged if spring is over-
tensioned.
WWW.TMGINDUSTRIAL.COM
P14/20
Toll Free:1-877-761-2819
