TMC LI6BM, User Manual, Page: 109 / 113

Chapter 11 LI6BM and the Databook Case
LI6BM User’s Manual 105
3-3. Install the thin I/O panel plate inside the case. Be careful not to
cut yourself in doing so. The thin metal plate has six protruding clips
that should be inserted to their respective hole on the back panel.
3-4. Install the CPU retention module onto the LI6BM
motherboard.
3-5. Install the motherboard into the case.
3-6. Install the game port cable onto the motherboard (J22 header)
and screw the connector onto the case.
3-7. Install the power supply onto the case.
3-8. Remove the power supply top screw diagonally opposite the
corner of the case. This screw will be used to fix the riser card metal
support.
3-9. Insert the BL21PI Riser Card onto the motherboard. Screw the
card onto the riser card metal support.
3-10. Screw the metal support to the power supply. Use the screw
that was remove from the power supply as mentioned in 3-8.
3-11. Screw the FDD plastic siding onto the left side of the floppy
disk drive. Refer to the figure on the next page. Note that the FDD
plastic siding has six holes on it while the HDD plastic siding has
two holes.
Make sure to use the small-thread ‘mm’ screws for
the FDD and CD-ROM drives and use the big-thread ‘inch’
screws for HDD drive to avoid damage to the drives.
3-12. Install the floppy disk drive into the front panel unit.
Back Panel
3-9 Screw the
riser card to
the metal
support.
3-7 Install the power
supply into the
case.
3-8 Remove this
screw.
3-10 Screw here
to attach the
riser card
support.