ProPlex Opto-Splitter user manual v1.2.7, 080619
- 4 -
•
Never disconnect power cord by pulling or tugging on the cord.
Caution! There are no user serviceable parts inside the unit. Do not open the housing or
attempt any repairs yourself. In the unlikely event your unit may require service, please
contact your distributor.
F
USE
R
EPLACEMENT
The ProPlex Opto-Splitter 2x10 RDM uses a 2.0A, 250V barrel fuse, 5x20mm (0.2x0.8 in.). The
ProPlex Opto-Splitter 2x8, Opto-Splitter 2x8 RDM, Opto-Splitter Mini, and Opto-Splitter Mini RDM, use
a 1.0A 250V barrel fuse, 5x20mm (0.2x0.8 in.).
To replace fuse:
1. With a screwdriver turn the fuse cap counter-clockwise to remove fuse cap with fuse.
2. Replace fuse attached to fuse cap.
3. Reinsert fuse cap with new fuse and tighten clockwise.
M
OUNTING
/R
IGGING
–
P
RO
P
LEX
M
INI
E
NCLOSURES
Orientation –
ProPlex Mini units may be mounted in any position, using the standard
yoke. Always make sure there is adequate room for ventilation.
Rigging –
Always consult a certified rigging specialist before suspending any device
overhead.
Use ProBurger
®
couplers or equivalent C- or O-type clamps for attaching to truss. After
establishing the desired position, tighten all appropriate bolts.
•
Always use safety cables!
•
When selecting installation location, consider routine maintenance.
•
Never mount Mini enclosure where it will be exposed to moisture, high humidity,
extreme temperatures, or restricted ventilation.
Disconnect the power cord before replacing a
fuse and always replace with the appropriate
fuse.
