TM INDUCTION HEATING
8
ET 2.0 |
`
Always use the magnetic temperature sensor (hereafter referred to as the ‘sensor’) for
heating in Temperature Mode.
`
Connect the sensor by inserting the plug into the socket at the front of the heater, with the
red dot facing upwards.
`
Place the sensor on the workpiece, close to the bore (see fig. 1). Make sure that the surface
used for the sensor is free of grease and/or oil. To avoid overheating the workpiece, never
place the sensor on the outer ring (see fig. 2).
POSITIONING THE MAGNETIC TEMPERATURE SENSOR
Treat the magnetic temperature sensor with care. It is a valuable part of the
heater and can easily be damaged through careless handling. After use, we
suggest that it is placed on the side of the vertical pole.
Fig. 1
Fig. 2
OPERATION
4.
When the operator switches the heater on, the LED display will show
110°C (230°F). With the buttons labeled UP and DOWN you can
increase or decrease the temperature. The temperature range for
Easytherm is from 0°C (32°F) to 240°C (484°F).
Select the preferred temperature and press the button labeled START/
STOP to start the heating process. The LED display will now show the
the measured temperature of the workpiece.
Once the selected temperature is reached, an acoustic signal can be
heard and the LED display will flash. Press the START/STOP-button to
stop the heating cycle and remove the temperature sensor from the
workpiece. Remove the workpiece from the induction heater. During
the heating cycle, the progress can be stopped at any moment by
pressing the START/STOP-button.
TEMPERATURE MODE
Available on
Easytherm 1 / 2 / 3.5 / 15 /30
After heating cycle completion: As soon as the temperature drops 5°C/°F, the heating cycle will
automatically restart and heat until the selected temperature is reached (again). This process
will repeat for a maximum of 5 times. Press the START/STOP-button to stop the heating cycle.
Feature: Temperature hold
