TM INDUCTION HEATING
10
ET 2.0 |
TROUBLESHOOTING
6.
If a loud vibrating noise is heard:
`
Stop the heating cycle by pressing the start/stop button.
`
Are the contact surfaces clean and greased sufficiently?
`
Is the yoke 100% in contact with the surface? If this is not the case, adjust the yoke with
instructions below.
1. Check if the machine milled surface is smooth.
2. Place yoke or pivoting yoke on the heater.
3. Unscrew the bolts between pivoting point and yoke a quarter turn.
4. Turn on the heater and start a heating cycle.
A bearing is not required.
5. Fasten the bolts again during the heating cycle.
6. Stop the heating cycle and the yokes are now adjusted.
3
2
1
