IMPORTANT PRECAUTIONS
DO NOT
press both the indoor buttons at the same time as this could cause an overload.
DO NOT
drop, shake, or subject units to shock.
DO NOT
clean the units with benzene, thinners, or any solvents. Wipe off dust and marks with a
soft cloth slightly moistened in mild soapy water.
DO
disconnect the unit from the main power even when the unit is not to be used for some time.
DO NOT
connect to the Public switched telephone network.
Camera
CCD
SYNC system
Frame
Lens
Output signal
Illumination
Power consumption
Telephone call system
Signal system
Scanning system
Auto iris
Microphone
Audio amp
Black and White 1/3” CCD
Internal
30 / sec
F=2.0 Fixed focus,
110 degree view angle.
Composite Video 75ohm
1Vp-p
0.1 lux (Auto lighting)
DC 12V 4W
4 wire
CCIR / EIA
625(CCIR) / 525(EIA) Lines
Internal ALC system
Built-in Condenser Type
Built-in RX and TX
Monitor
Monitor
Scanning Frequency
Power consumption
Resolution
Input Signal
Dimensions (mm)
Weight(g)
4” Black and White flat type
EIA:15.75KHz(H) 60Hz(V)
CCIR :15.625KHz(H) 50Hz(V)
AC 90~240V, 0.8A
400 TV lines at center
Composite Video 75
Ω
1V p-p
190(W) X 230(H) X 52(D) mm
1,300g
6. Technical specification
NO
1
2
3
4
5
6
7
Problem
Nothing Works
Camera or Monitor do not work
No picture
Picture does not adjust to light
conditions
Monitor picture too dark
Interphone does not working
Volume is too low on calling tone
Check Point
Check to insure that AC cord is plugged
into a wall AC output
Check the wires to make sure they are connected
to the line terminals. Is the number of wires
matched correctly between outdoor camera unit
and indoor monitor?
Adjust BRIGHTNESS control
Direct light is hitting camera lens.
Adjust BRIGHTNESS control.
Is the modular jack from handset fimly inserted to
indoor monitor?
Adjust the call volume control.
7. Trouble shooting
Before asking for a serviceman check the system with diagram
