1
2
3
4
5
6
7
8
9
10
11
Inter-
phone
Inter-
phone
CMR1
Monitor
On/Off
Monitor
On/Off
CMR2 CMR3 CMR4
N.C
N.C
Audio
Audio
Ground
Ground
Video
Video
CMR1
Inter-
phone
CMR2
Monitor
On/Off
CMR3
Audio
CMR4
Ground
Door
Release
Video
Door
Release
N.C
Main
Slave
Camera
1 2 3 4 5 6
1 2 3 4 5 6 7 8 9 10 11
1 2 3 4 5 6 7 8 9 10 11
1 2 3 4 5 6 7 8 9 10 11
<CAMERA>
<MONITOR>
<VIDEO MEMORY>
(OPTION)
<SLAVE MONITOR>
(OPTION)
<SLAVE MONITOR>
(OPTION)
PLUG
AC INPUT
PLUG
AC INPUT
PLUG
AC INPUT
DOOR OPEN KEY
DO NOT
expose the units to direct sunlight or any strong reflected light. Avoid extremely bright
locations for the indoor unit as the monitor screen image will be adversely affected.
DO NOT
install near to other electronic equipment such as computers, TV’s, VCRs etc.
DO NOT
install near acid oxides, ammonia or any harmful gas.
DO NOT
press both the indoor buttons at the same time as this could cause an overload.
A recommended installation height is approximately 145 cm from ground level for the indoor unit
(if wall mounted) and around 140 cm from ground level for the outdoor unit.
Please note, extra care must be taken when outdoor unit is exposed to direct sunlight, rain & extreme
moisture.
3. Installation
3-1. Cable connection
When installing this Video Doorphone System, please follow the steps;
Important :
Use only alarm cable or telephone cable for inter-phone. Installation length of the line
between indoor and outdoor units should not exceed 50 meters. The recommended cable is
available from your retailer.
1. Following the wiring diagram below, connect the exact wires to the terminals of camera and door
release facility as it is polarity.
2. If the Electronic Door Release facility is to be used, connect the Door Open Key to terminals as
shown, key button 12 Volts 500mA.
3-2. Wiring Diagram
1. A master monitor cannot be used as a slave monitor and a slave monitor cannot be used as a
master monitor. therefore a slave monitor cannot be used as the first monitor in-line.
2. Memory module can be connected to master monitor only.
3. No lock release is supplied with this unit. However, if you do require a lock release then please
contact us on 0121-789-8111. Please note that no lock release can be fitted to a UPVC type of
door or frame.
