8-5
8.2.2.2. Procedure of fuel tank filling
Ground the airplane. The airplane ground point is located on the engine
exhaust pipe.
During the filling the fuel wing tanks do not support the ladder on the leading
edge of the wing. Do not lean on the airplane during filling.
Open the fuel tank cap.
Fill with necessary quantity of fuel.
When filling into the airplane, avoid fuel contact with the airplane finish which
may cause damage to surface of the airplane.
When the airplane is filled with fuel, wipe the filler neck fuel and close the fuel
neck filler cap.
Remove conductive interconnection between the filling device and the
airplane.
When fueling the airplane, ensure the airplane is electrically grounded by
verifying that the grounding wire located on the right main gear wheel
makes adequate contact with the ground’s surface. Also, ensure the
fueling container remains adequately grounded to fuel neck ring and
nozzle. A ground wire from the refueling container should be attached to
the engine exhaust pipe. The exhaust pipe is electrically connected to
the aircraft ground system as are all fuel tanks and tank opening ports.
8.3 Cleaning and care
8.3.1 Windows
The cabin windows surface should be cleaned only with an aircraft windshield
cleaner and one of the micro-fiber cloths which are provided. Do not wipe the
windows in a circular motion. If the windows are covered with dust, use flowing clean
water and lightly wipe the dust away with a clean hand (remove finger rings). This
will remove (flow away) the grit that will scratch the plastic surface. Apply a sufficient
but modest amount of cleaner to the windows surface and wipe in a long stroke
fore/aft
linear
motion with light pressure until the surface is clear. Attempt to lift the
dirt from the surface don’t rub it into the windows or light scratches will appear in the
sunlight reflections.
WARNING
CAUTION
