TKS AGRI Conveyor TR, Operator'S Manual

Page: 21 / 46

E
I
J
TKS
21
The Conveyor TR is packed and delivered as
per the illustration.
See Fig. 6
When assembling the TR Conveyor TR,
remember to dispose of any cardboard, straps
and plastic inan environmentally friendly man-
ner.
Fitting of new Conveyor TR:
• Fit a 1 m return section (A) together with one
or more mid-sections (B) , depending on the
required length.
• Fit the sections together in the splice plates
(C) using the associated screws.
• Then fi t a 1 m operating section with a gear
motor (D) at the end of the Conveyor TR
• Mount the belt the correct way. See Fig. 7a
• Thread the belt and carrier (E) on and lock in
position using a belt splice pin (F) .
• When the belt has been threaded into
position, fi t the base plates (G) to the under-
side of the Conveyor TR using theassociated
screws.
• Check that the belt tracks straight. This is
done by tightening/slacken the screws (J)
on the driving roller on the return section on
both sides. Tighten the belt so that it doesn’t
spin on the driving roller.
See Fig. 7
If the Conveyor TR is to be installed on a slope
using a supporting foot
(H) and the slope
exceeds 35
O
, a refi lling funnel (I) may be used
instead.
See Fig. 7a and 7b
Supporting foot
The supporting foot (H) is supplied as extra
equipment.
Flat-packed with associated screws.
See the fi tting instructions in
Fig. 7b
Fig. 7a
Fig. 7b
H
IT_06
IT_09