TKH Security Proposal | RFP Name | RFP Number
TKH Security | Siqura WP10 |
Installation manual v2.0
7
Control boardsettings
M1
WARNING HIGH VOLTAGE Power Supply input 100÷240VAC (+/- 10%) 60W max
M2
Low Voltage Power Supply Input 24VAC/DC (+/- 10%) 60W max
M3
Level Alarm Output: when the tank is empty, normally open or closed based on J1
M4
Level Sensor Input, connected to a Float Switch, configurable normally open or closed by J2
M5
Voltage Enable Input, activates the Pump Motor when 24VAC/DC (+/- 10%) is applied
M6
Pump Motor Output, connected to the Water Pump
M7
Digital Enable Input, activates the Water Pump when the input is closed
DIS1-1
Power Supply Input Configuration:
100~240Vac or 24Vdc: SW1= OFF (0)
24Vac (by default) SW1= ON
(1)
DIS1-2 Pump Motor Output Level Configuration:
SW2 shall always be OFF (0)
J1
Level Alarm Output configuration (NC or NO)
J2
Reserved
J3
reserved
J5
Pump motor Output Enabler, turns the Water Pump always ON
S1
Pump Motor Output Test Button, when pressed enables the Water Pump
F1
HIGH VOLTAGE Power Supply Fuse: T 4A (250VAC)
F2
Low Voltage Power Supply Fuse: T 6,3A (250VAC)
DL1
Power Supply GREEN LED turns ON when a power supply is provided
DL2
Water Level Alarm RED LED, turns ON when empty tank is detected
DL3
Pump Motor Output YELLOW LED, turns ON when the Water Pump is enabled
