![background image](http://html1.mh-extra.com/html/tivoli-audio/networks/networks_owners-manual_1120470007.webp)
7
“Connecting”. After connecting you may begin using your N.
*If you prefer to connect using a direct Ethernet cable, connect the cable (not included) to the
Ethernet input located on the bottom of N
If you are prompted to enter a password, your network uses a security encryption system.
You must enter the correct code to allow N to communicate with your network.
The codes are case sensitive so be sure to enter the code exactly as it is configured in your
wireless network. Use the
pq
buttons to change character pages. Use the
tu
buttons to
highlight characters and the Select button to enter the character. After you’ve selected all the
characters for your password, press the ‘
’ character to enter your password.
a) the ‘
<’ symbol = back space if you make an error
b) the ‘
’ symbol = enter completed password
c) the ‘
C’ symbol = cancel process and return to previous menu
When selecting a blank space it will be represented by a blank space
followed by an underscore indicating the position of the next character.
N will now connect to your network.
If the N fails to connect with the first attempt and you are sure you entered your password
correctly, press the ‘
’ symbol to repeat the connection rather than re-enter your password all
over again.
If your network uses an encryption system, Tivoli Audio strongly advises against turning it off. You
should maintain proper security of your network. If several N are available, you should
connect only to the network you have an agreement to use.
If you experience difficulty connecting to your network, consult our website
(http://networks.tivoliaudio.com) or contact your dealer/distributor for further assistance.
Should you ever need to manually initiate a network scan you can do so by entering the “IR
Setup” menu and selecting “Scan N”. The “IR Setup” menu will also allow you to view
and edit current settings.
Wired/Wireless connection:
When changing from wireless to wired, after connecting the Ethernet
cable to the input on the bottom of your N radio, enter the “IR Setup” in the menu, access
the “Manual Settings” option and select “Wired”. Be sure the cable is connected first before
switching to Wired mode. The wireless connection is now disabled and no signal strength will
be shown on the display. When changing from wired to wireless, rather then select “Wireless”,
select “Scan for N” in the “IR Setup” menu and pick up from Step #6 under “Getting Started”.
WiFi Signal Reception:
The WiFi antenna is incorporated inside the N. Locate the
N for best WiFi signal reception. Reception can be affected by your home’s type of
construction as well as other causes of interference. In Internet radio and music player modes
the display will show WiFi signal reception in the lower right corner. This will not be shown when
using an Ethernet cable. Note: WiFi N can sometimes impart very low level random noise
into the audio signal. This is not a fault of the N radio.
7.
Summary of Contents for NetWorks +
Page 1: ...OWNER S MANUAL...
Page 2: ......