Tighten to very snug fit.
MOUNTING INSTRUCTIONS
4
drilled holes.
Note: Do not wrench bolts too tight. You may strip the plugs out of the
6.
After determining the ideal height to hang the frame, hold the frame
1.
firmly to the wall with two adults and level to assure its straight. Mark
all four holes with a pencil or punch for mounting.
Use a masonry drill bit starting with 7/16". Once hole is made, try and
2.
tap the plug into the hole by gently tapping on the end with a hammer.
If this does not work then try a 1/2” size. If you are using the 1/2” drill
bit then go half way and test the plug, keep testing until it can go in far
enough to expand properly.
Helpful hint: Be sure you drill straight. If not, this will make the
mounting process difficult in leveling the unit.
Once hole is drilled, take mounting plug and test the size of hole. You
3.
should not be able to slide the plug in without resistance.
Note: Its better to have a slightly smaller hole and use a hammer to
tap it in then it is to be able to slide it in and out with your hands.
Once the size of the hole is confirmed and you have tapped in all 4
4.
plugs, lift frame up to mounting plugs. This will require two people.
Start tightening the bolts systematically on frame (corner to corner to
5.
corner to corner) until bolts start to expand plug spacer.
Cement or Masonry Wall Mount Instructions
Note: If you are mounting to a cinder block wall and can clearly see the
blocks, try to position the holes you are about to drill so they will drill
through and into the cavity section of the blocks.
