Page 9
For technical questions, please call 1-888-866-5797.
Item 58058
SaFety
Opera
tiOn
Maintenance
SpeciFica
tiOnS
Maintenance
tO preVent SeriOUS inJUry FrOM tOOL FaiLUre: Do not use damaged equipment.
if damage or abnormal operation occurs, have the problem corrected before further use.
BeFOre eacH USe, inspect the general condition of the tool. check for loose
hardware, misalignment or binding of moving parts, cracked or broken parts, damaged
electrical wiring, and any other condition that may affect its safe operation.
note:
Replace the Lens Cover(s) if they are cracked, scratched, soiled, pitted or damaged in any way. For
additional information regarding the parts listed in the following pages, refer to
Parts List and Diagram
on page 11.
Outer Lens replacement
1. Remove the Lens Frame from the Helmet Shell.
Once the Lens Frame is removed, remove
the Outer Lens from the Helmet Shell.
2. Remove any protective film from both
sides of the new Lens Cover.
3. Install new Front Lens Cover into Gasket and
assemble Lens, Gasket, and Lens Holder into
Shell the same way they were removed.
nOtice:
Front lens must be in place during
welding. Weld spatter will permanently damage
Auto-Darkening Filter and voids warranty.
inside Lens cover replacement
1. Remove the old Inside Lens Cover by
pulling it up at the finger notch.
2. Remove any protective film from both
sides of the new Lens Cover.
3. Line up the new Inside Lens Cover with the flanges
at the sides of the lens and snap it into place.
inside
Lens
cover
Finger notch
Figure D: inside Lens panel Setup
Battery
Housing
