Page 7
For technical questions, please call 1-888-866-5797.
Item 58058
Sa
F
ety
Opera
ti
O
n
Maintenance
Speci
F
ica
ti
O
n
S
controls
Option
Selection
Mode
Selection
Level
Selection
Display
Mode
Indicator
Figure B: controls
Mode Selection and Shade number
1. Use Set Switch to choose the Shade option.
2. Press Mode Switch to choose between
Shade 5-9 or Shade 9-13. Selections will
be shown on the display screen.
3. Using the Shade Guide Chart on page 5,
select the shade range required using the Mode
switch and then adjust the Shade Level upwards
or downwards by using the Range switch.
note:
If a selection of shades are recommended
for your application, try the darkest setting first.
4. To switch between Cut and Grind
mode, press the Mode switch.
note:
To switch modes, you must not be in “Set” options.
5. The light next to “Grind” or “Cut” will
indicate the mode after switching.
caUtiOn!
after using the Grind Mode set the Helmet
to the proper shade setting before welding again.
6. The shade number can be set from 5 to 9
(cutting) or from 5 to 9 and 9 to 13 (welding)
depending on the shade range selected.
time Delay and Sensitivity
1. At the moment the welding operation is started,
the filter screen automatically changes from
clear to dark. The Delay function can vary
the amount of time it takes the filter to return
to a clear state after welding stops. Press
Set Switch to select the Delay option.
2. Use the Range Switch to shorten or lengthen the
delay time. The shortest delay time is 0.1 seconds
(set to 1 using Range Switch). The longest delay
time is 0.9 seconds (set to 5 using Range Switch).
3. The sensitivity setting changes the amount of
light needed to make the filter react. Press the
Set Switch to choose the Sensitivity option.
4. Use the Range switch to raise or lower the
sensitivity (five stages of sensitivity are
available).1 indicates the lowest sensitivity,
and 5 indicates the highest sensitivity.
