EN
33
In
more
detail...
TTI884COM
EN
Troubleshooting
Troubleshooting
Therefore check the product using this section. In most cases the problem can
be solved quickly.
WARNING!
Only perform the steps described within these instructions!
All further inspection, maintenance and repair work must be performed
cannot solve the problem yourself!
Problem
Possible cause
Solution
1. Product does
not start
1.1. Forward / reverse
rotation control switch
at centre lock position
1.2. Battery pack not
properly attached
1.3. Battery pack discharged
1.4. Battery pack damaged
1.5. Other electrical defect
to the product
1.1. Push forward / reverse
rotation control switch
to left / right
1.2. Attach properly
1.3. Remove and charge
battery pack
1.4. Replace with a new one
of the same type
1.5. Check by a specialist
electrician
2. Product does
not reach full
power
2.1. Battery pack capacity
too low
2.2. Air vents are blocked
2.3. Incorrect torque ring
setting
2.1. Charge battery pack
2.2. Clean the air vents
2.3. Choose higher torque
ring setting
3. Unsatisfac-
tory result
3.1. Drill / driver bit is worn
3.2. Drill / driver bit not
suitable for intended
operation
3.1. Replace with a new one
3.2. Use suitable drill / driver
bit
4. Product sud-
denly stops
4.1. Product overloaded
4.2. Battery pack discharged
4.3. Battery pack too hot
4.1. Remove the product
from the workpiece and
switch it on again
4.2. Remove and charge
battery pack
4.3. Remove battery pack
and let it cool down
MNL_18V 2X 2AH Li-ION BRUSHED COMBI DRILL_V2_211220.indd 33
12/20/21 11:39 AM
