48
Fig. 34
Fig. 35
> Using a square [63], set the blade to exactly 90°. (Fig. 34)
> If the blade stops bevelling before it gets to 90°, loosen the 90° stop screw [64]
(located on the left under the table) (Fig. 35) with the hex key (not included), and
then adjust it to 90°.
> With the blade set at 90°, slowly turn the 90° stop set screw until you
feel resistance. Bevel the blade away from 90° a little, and then back to the stop.
> Re-measure the angle, and repeat the stop adjustment as necessary until the
blade stops at 90°.
> Set the 45° stop in the same way with a trianlge square [65]. The set screw [66]
for the 45° stop is located on the right under table.
Product functions
TTB674TAS
by TITAN
In
more
detail…
GB
IE
63
64
66
