7
TN-1341 INSTRUCTION MANUAL
BELT AND BELT COVER
The TN-1341 is typically equipped with a 750W servo motor and while there are options for this on
the Options page (needle positioner, speed reducer, etc.), the basic set up for the TN-1341 will be
as follows:
1.
Adjust the belt tension with the height of the motor so that the belt sags 15 mm when the
center of V belt is applied with a 9.8 N load.
2.
Please note, that if the motor belt is too tight, the machine may labour thru stitching and
cause the motor to have errors. If the belt is too loose, you will have slipage as you sew
and this can also cause motor errors, especially if you have the needle positioning encoder
attached to the machine.
Figure 3
