10
TN-1341 INSTRUCTION MANUAL
LUBRICATION
It is important to remember that Titan Sewing Machines are produced using some of the highest
quality components and assembled and tested thoroughly to ensure the machines can handle
factory operation day in and day out from multiple operators and shifts. Noting that, you may
choose to alter your lubrication requirements based on the amount of use you are putting your
machine through. If you do not use your machine for an extended amount of time, you should
consider oiling your machine before you put it away and after, when you first take it out to ensure
the machine is properly lubricated before use. The TN-1341 has (3) major components to its
lubrication portion of the machine. They are: The face plate head unit, the upper body and the
shuttle arm area.
LUBRICATING THE FACE PLATE HEAD UNIT
1.
Loosen and remove screw A.
2.
Open the face plate in the direction
of arrow mark B.
3.
Apply an adequate amount of oil
once a day to the points marked with
the arrow marks.
NOTE: you may notice certain areas of
your machine may have grease on
components. If there is grease on any
of the areas that should be oiled or
lubricated, please do NOT oil this. If
you place oil on to a greased area, this
will cause the oil to break down the
grease and it will liquify and could
cause this to drip onto your project
area.
4.
Close the face plate.
5.
Tighten and attach screw A.
Figure 6
