background image

SAFETY

This generator was designed for specific applications. DO NOT attempt to modify the unit in any way or use
it for any application that it was not designed to do. Ask the dealer or contact the factory if you have any
questions concerning the generator’s application.

Warnings and cautions in this manual and on decals and tags on the unit are not all inclusive. It would be
impossible to anticipate every circumstance that might involve a hazard. Handling, operating, or servic-
ing this unit by any procedure not recommended by the manufacturer may render this equipment unsafe
and may pose a threat to you or to others.

CAUTION! The engine exhaust contains chemi-
cals known to the State of California to cause can-
cer, birth defects, or other reproductive harm.

The generator produces a very powerful volt-
age that can cause extremely dangerous elec-
trical shock. Avoid contact with bare wires, ter-
minals, etc. never permit an unqualified per-
son to operate or service the generator.

Never handle any kind of electrical cord or de-
vice while standing in water, while barefoot or
with wet hands or when feet are wet. Danger-
ous electrical shock could result.

The National Electric Code requires that the
frame and external conductive parts be prop-
erly connected to an approved earth ground.
Local electrical codes may vary. Check with an
electrician for local grounding requirements.

Use a ground fault circuit interrupter in any
damp or highly conductive area such as metal
decking or steel work.

Do not use worn, bare, frayed or otherwise dam-
aged electrical cords or wiring with the genera-
tor. A defective cord may result in electrical
shock or may cause damage to equipment.

Do not expose unit to excessive moisture, dirt
or corrosive vapors. Unit must be operated on
a level surface.

Do not overfill the fuel tank. Always allow room
for fuel expansion. Fuel could overflow and cause
fire or explosion if tank is overfilled. Allow for a
20 minute cool down before refueling. Never
refuel tank while engine is running.

Only operate this unit outside with adequate venti-
lation. This generator’s exhaust produces carbon
monoxide gas that can cause unconsciousness or
even death.

Never store a generator with fuel in the tank where
fuel vapors could be ignited by a flame, spark, or
pilot light from an appliance such as a furnace, water
heater, or clothes dryer.

Always allow a minimum of 2 feet of clearance on
all sides for ventilation while unit is operating. Al-
low 2 feet of clearance from all combustibles.

Generator must always be stopped or started with
all loads unconnected. Start the engine and let it
stabilize before connecting any loads. Disconnect
all loads before shutting down the generator.

Never insert any object through the cooling slots
of the engine. You could damage the unit or cause
injury.

NEVER OPERATE THE GENERATOR:

In rain
In an enclosed compartment
If connected devices overheat
If electrical output is lost
If engine or generator sparks
If flame or smoke is observed
If unit vibrates excessively

CAUTION! If it is your first time starting the gen-
erator, allow it to run for 30 minutes before con-
necting electrical loads. This is for wet seating
purposes

Caution: Customer takes full responsibility for use

of this unit as a home generation system

.

3

Summary of Contents for TG 9000ES













Reviews: