Titan TCS973, User Manual

Page: 12 / 65

-12-
13. Remove the middle cover. Carefully pull the PCB board and headlight board through
the middle cover. Then pull the two motor wires through the middle cover. Pay attention
to reserve the two felt washers properly for re-installation.
14. To remove the wood agitator, first remove its non-belt side. Lift the end cap up as
shown and release the non-belt side from the base.
15. Remove the belt side of the agitator. Use a suitable tool (e.g. a screwdriver) to carefully
pry off the end cap at position 1 as shown, and then release the belt side from the
base.
Motor Wires Wood Agitator
Middle Cover
Headlight Board
PCB Board
Felt
Washers
I
II
1