TA 250 / TA 450
(0001)
63
/
112
Fault
Cause
Remedy
Plastic straps not sealed
properly, the seal is not OK. The
upper strap is not cut completely
or it is irregular.
Welding time too short.
Check value set on the operator
panel and correct, if required.
Gripper plate welding
(8)
and/or
welding plate
(51)
were polluted,
gearing is worn or defective.
Clean gripper plate welding
(8)
and/or welding plate
(51)
, check
gearing, replace when damage
becomes visible.
Cutter
(47)
is worn or defective.
Check cutter
(47)
for damage and
replace it if required.
Welding motor
(503)
and/or
circuit board
(19)
defective or
loosen cable connections.
Visual check for loosen cable
connection, re-establish the cable
connection if required. Replace
parts when damage becomes visible
and/or contact TITAN-Service.
Li-Po storage battery defective
or insufficiently charged.
Check charge of Li-Po storage
battery and recharge or, if required,
replace it.
Use of inappropriate plastic
strap.
Use appropriate plastic strap, ask
your TITAN
– Adviser for advice.
During welding both straps are
cut.
Welding time too long and/or
strap tension too strong.
Check value set on the operator
panel and correct, if required.
Gripper plate welding
(8)
and/or
welding plate
(51)
were polluted,
gearing is worn or defective.
Clean gripper plate welding
(8)
and/or welding plate
(51)
, check
gearing, replace when damage
becomes visible.
Following the welding cycle the
tool cannot be detached from
the strap, lever 3
(97)
must be
actuated with enormous force
being applied.
De-tension unit is not released /
de-blocked.
Slightly pull lever 3
(97)
(do not pull
it completely) and check whether
the non-return unit is de-blocked.
Contact TITAN-Service.
De-tension unit is blocked by
something or it is damaged.
Check if foreign objects are found in
the de-tension unit or if visible
damage can be detected. Contact
TITAN-Service.
Gear
(77)
is damaged.
Check if the gear
(77)
and the feed
wheel
(85)
can be turned easily and
evenly. Contact TITAN
– Service.
H TA 250 / 450 EU 38/15
Summary of Contents for TA 250
