12
The following techniques, if followed, will assure professional
painting results.
Hold the gun perpendicular to the surface and always at equal
distance from the surface. Depending on the type of material,
surface or desired spray pattern, the gun should be held at a
distance of 12 to 14 inches (30 to 35cm).
Move the gun either across or up and down the surface at a
steady rate. Moving the gun at a consistent speed conserves
material and provides even coverage. The correct spraying
speed allows a full wet coat of paint to be applied without runs
or sags.
Holding the gun closer to the surface deposits more paint on
the surface and produces a narrower spray pattern. Holding the
gun farther from the surface produces a thinner coat and
wider spray pattern. If runs, sags or excessive paint occur,
change to a spray tip with a smaller orifice. Conversely, if
there is an insufficient amount of paint on the surface or you
desire to spray faster, a larger orifice tip should be selected.
APPLICATION TECHNIQUES
If conditions are windy, angle the spray pattern into the wind to
minimize drifting. Work from ground to roof. Do not attempt to
spray if wind is excessive.
For corners and edges, split the center of the spray pattern
on the corner or edge and spray vertically so that both
adjoining sections receive approximate even amounts of
paint.
Maintain uniform spray stroke action. Spray alternately from left
to right and right to left. Begin movement of the gun before the
trigger is pulled.
Avoid arcing or holding the gun at an angle. This will result in
an uneven finish.
Proper Technique
Wrong Technique
When spraying with a shield,
hold it firmly against the surface. Angle the spray gun slightly away from the shield and toward the
surface. This will prevent paint from being forced underneath.
Shrubs next to houses should be tied back
and covered with a canvas cloth. The cloth should be removed as soon as possible.
Titan Gun Extensions are extremely helpful in these situations.
Nearby objects such as automobiles, outdoor furniture, etc., should be moved or covered
whenever in the vicinity of a spray job.
Be careful of any other surrounding objects that could be damaged by overspray.
PROPER LAPPING
(overlap of spray pattern) is
essential to an even finish. Lap each stroke. If you are
spraying horizontally, aim at the bottom edge of the
preceding stroke, so as to lap the previous pattern by
50%.
