Titan Compact 190, Manual

Page: 25 / 132

19
Compact 190 GB
Connecting the device
a properly earthed socket outlet with earthing contact must be used for connection. The connection must be equipped
with a residual current protective device with InF ≤ 30 ma.
Setting up the unit
Danger
When working indoors:
Vapors containing solvents may not be allowed to build up in the area of the device.
Setting up the unit on the side a way from the sprayed object.
a minimum distance of 5 m between the unit and spray gun is to be maintained.
When working outdoors:
Vapors containing solvents may not be allowed to blow toward the unit.
note the direction of the wind.
Set the unit up in such a way that vapors containing solvents do not reach the unit and build up there.
a minimum distance of 5 m between the unit and spray gun is to be maintained.
Maintenance and repairs
Danger
Before carrying out any work on the device, relieve the pressure and unplug the power plug from the socket.
Cleaning the unit
Danger
Danger of short circuit through penetrating water!
never spray down the unit with high-pressure or high-pressure steam cleaners.
Cleaning units with solvents
Danger
When cleaning the unit with solvents, the solvent should never be sprayed or pumped back into a container
with a small opening (bunghole). an explosive gas/air mixture can be produced. The container must be
earthed.
Do not clean the device or accessories with flammable solvents with a flash point below 21 °C.
Earthing of the object
The object to be coated must be earthed.
Thermal release
The device is equipped with a thermal release which disconnects the device in case of overheating. In this case switch the device
off, turn the selector switch to the PRIME position (vertical), remove the mains plug and allow device to cool down for min. 30
minutes. Eliminate the cause of heating, e.g. slots for air intake covered.
Description (Fig. 1)
1 Pressure regulator 2 Hose connection
3 Inlet valve pusher 4 Hose holder
5 Telescopic handle 6 Spray Gun
7 Nozzle holder 8 Paint nozzle 310 (purple) and dispersion nozzle 419 (red)
9 ON / OFF Switch (0 = OFF, I = ON) 10 Selector switch
11 Filter red (1 unit) for spray nozzle 310
Filter white (2 units) for spray nozzle 419*
12 Tool box
13 High-pressure hose 14 Return line
15 Inlet filter 16 Suction hose
17 Holder for paint container 18 Automatic lubricator (button to lubricate pump)
19 Oil 20 Operating instructions
* second filter pre-installed in gun
Coating Materials Suitable for Use
Dispersion and latex paints for interior use.
Water-based and solvent-containing lacquers and glazes. Paints, oils, release agents, synthetic enamels, PVC lacquers, undercoats,