TTB926STM
by TITAN
Getting
started...
EN
13
Filling with water
WARNING!
When refilling with water during use, disconnect from the
power supply and wait for 15 minutes before adding water into the
water tank (4). There is a risk of scalding with steam and / or hot water.
The water tank (4) has a capacity of 6.5 litres. Fill the water tank (4) as follows:
1. Ensure the product is disconnected from the power supply and placed on a
flat, stable and heat-resistant surface.
2. Unscrew the safety cap (1) anti-clockwise and remove it from the water tank
(4) (Fig. 7).
3. Pour water into the water tank (4) until the water level reaches between the
MIN
and
MAX
markings on the water level indicator (4c) (Fig. 8). Use a funnel
if necessary. Do not overfill. Drain the water tank (4) if the water level exceeds
MAX
level.
4
1
Fig. 7
4
4c
Fig. 8
4. Screw the safety cap (1) back onto the water tank (4). Do not overtighten.
NOTE:
Before refilling, rinse the water tank (4) with 1 litre of water first
to reduce lime scale deposits.
It is not necessary to use distilled water.
It is possible to shorten the preheat time by adding hot water, but never
pour boiling water into the water tank (4).
Before you start
MNL_TTB926STM_2200W Wallpaper Stripper_GB_V8_220623.indd 13
MNL_TTB926STM_2200W Wallpaper Stripper_GB_V8_220623.indd 13
2022/6/23 下午5:04
2022/6/23 下午5:04
