Titan Lifts HD2P-12000F, Installation, Operation & Maintenance Manual

Page: 12 / 36

9
11) Install the cylinders: Put one cylinder into each carriage by sliding it all the way down to
the top of the cylinder mount at column base. Make sure the “tip” on the bottom of the
cylinder will fix into the center hole on top of the cylinder mount in base. Pull the pre-
attached leaf chain in both sides up and over the chain sheave on top of the cylinders.
Refer to Fig. 4.
12) Connecting the hydraulic hoses, as shown on Fig 2.
13) Mount the power unit on lift as shown in Fig. 2.
14) Mount the floor plate (66).
15) Install the swing arms on the carriages using the included 1 1/2” diameter pins. Check
for proper engagement of the arm lock- the rack on the lock should fully engage the
gear on the arm.
16) Adjust the carriage cables tension. Adjust each cable to approximately 1/2” side-
to-side play. Check the latch releases to insure the carriage is still sitting on the
appropriate latch.
17) Remove the fill cap from the power unit and fill the oil tank reservoir. To fill the oil tank
resevoir, the lift must be completely lowered. FIll the oil tank with 3 gallons of premium
quality AW-32, ISO-32, or AW-46 Hydraulic Oil.
18) Make the Electrical hookup to the power unit.(220V Single Phase). It is recommended
that a 220 Volt, 30 Amp twist lock plug be installed in the power line just ahead of the
power unit. Size wire for 30-amp circuit.
19) Do not place any vehicle on the lift at this time. Read the operation instructions (pg 12-
14) and cycle the lift up and down several times to ensure safety latches click together
and all air is removed from the system. Ensure all hydraulic fittings are tight and not
leaking. To lower the lift, the safety latches releases must be manually released.
Latches will automatically reset once the lift ascends approximately 17” from base. If
latches click out of sync, tighten the cable on the one that clicks first.