Titan Lifts HD2P-12000F, Installation, Operation & Maintenance Manual

Page: 11 / 36

8
6-INSTALLATION INSTRUCTIONS
PLEASE READ THIS INSTRUCTION BEFORE STARTING TO OPERATE THE LIFT.
Check for ceiling clearance to confirm the lift can be set up in your bay.
1) After unloading the lift, place it near the intended installation location.
2) Remove the shipping bands and packing materials from the unit.
3) Remove the packing brackets and bolts holding the two columns together (do not
discard bolts, they are used in the assembly of the lift)
4) Once the lift location is decided, chalk the center line in the bay and ensure that the
proper lift placement is observed from walls and obstacles. Also check the ceiling
height for clearance in this location. NOTE: the power unit column can be located on
either side.
5) You are now ready to stand the columns upright.
6) Position the columns facing each other 148” outside base plates.
NOTE: The power
unit column is referred to as the main side column and the non power unit column is
referred to as the offside column.
7) Using a 3/4” concrete drill bit, drill the anchor holes in the main side column, installing
anchors as you go. Use a block of wood or rubber mallet to drive anchor bolts in.
8) Using a level , check column for side-to-side plumb and front-to-back plumb. Use 3/4”
washers or shim stock, placing shims as close as possible to the hole locations. This
will prevent bending the column bottom plates. Tighten 3/4” anchor bolts to 85-lbs.
NOTE: DO NOT USE IMPACT WRENCH.
9) Using a tape measure, measure from front corner of the base on main side column to
the opposite front corner of the offside column to ensure columns are square. After
confirming the dimensions, repeat steps 7&8 for offside column installation. Ensure
the column is plumb and check floorplate attachment (66) BEFORE drilling the anchors
for the offside column.
10) After confirming the dimensions and that the column is plumb, drill and anchor offside
column as described in steps 7&8.