11
6.
The log splitter must have at least seven feet of clearance from combustible material. It
needs to be on a dry and level surface with good footing. Do not work on mud, ice, brush, or
snow. When using the log splitter, the work zone must be always maintained.
NOTE: Serious accidents can happen when other people are allowed inside the work zone. Keep
everyone else outside the work zone while operating the control lever.
7.
Always wear safety gear, eye protection, gloves and work boots when operating the log
splitter.
8.
Start the engine and make sure the log splitter is on level ground before operating.
NOTE: The hydraulic oil needs to be above 10°F (-12C°) before starting the engine. Cold hydraulic
oil can damage the hydraulic pump.
If outdoor air temperature is below 32°F (0C°)
allow the log splitter to warm up by extending and returning the wedge several times before
splitting wood.
9.
Put the support leg in the down position to prevent the log splitter from moving
during operation and block both tires.
10.
Set the log splitter in either the horizontal or vertical position.
NOTE: HORIZONAL position is used for lighter logs that can easily be loaded onto the beam. The
VERTICAL position is used for either light logs or heavy logs that are difficult to load onto the beam.
Back injury can result from lifting logs onto the log splitter if proper lifting techniques are not used.
11.
Load a log onto the beam against the endplate (Max Log Length-26”).
Summary of Contents for 198374
Page 13: ...13 OPERATION INSTRUCTIONS...
Page 17: ...17 PARTS DRAWING PARTS LIST...