Tisira TFGC969E, User Manual

Page: 20 / 28

CONNECTIONS
GAS CONNECTION
x
The connection must be performed by an
authorised person according to the relevant
standards.
x
This appliance is suitable for use with
Natural Gas or ULPG. The gas range is shipped
from the factory set and adjusted for Natural
Gas. It can be converted for use with ULPG
following the instructions in this manual.
x
The connection must be made at the rear of
appliance. Ensure the pipe does not cross the
cooker.
x
The inlet not used must be closed off with
the cap and sealing gasket supplied.
x
The gas connection is male ½” BSP and is
situated 55mm from the right and 560mm from
the floor
ADJUSTMENT TO
DIFFERENT GAS TYPES
To perform the adjustments to different types of
gas, the qualified installer shall follow the
instructions given on this section.
Make sure that the gas supply pressure
respects the values presented in the table
“Burner and nozzle specifications” on page 18.
NATURAL GAS
This appliance leaves the factory set to operate
using Natural Gas.
Make sure that the Natural Gas regulator
supplied with the appliance is installed and, with
the triple ring burner operating at its maximum,
adjust the test point pressure to 1.0kPa.
UNIVERSAL LPG
To convert from Natural Gas to Universal LPG,
ensure that the Natural Gas regulator is
replaced by the Test Point Assembly supplied
with the appliance. Adjust the test point
pressure to 2.75kPa.
To adapt the appliance to a gas different from
that for which it was set up (see gas type label
inside the warming compartment door) proceed
as follows:
1. Remove the trivets
2. Remove the burners caps and diffusers
3. With a 7 mm socket spanner unscrew
and remove the injectors.
4. Replace the injectors with those
supplied corresponding to the gas
available (see burner and injector
characteristics table)
5. Replace the various parts proceeding in
reverse.
IMPORTANT!
Ɣ
Check the correct positioning of the
gas regulator. The arrow on the back of
the gas regulator must be oriented
toward the connector.
pg 20