18
E
N
G
L
I
S
H
TP04405 Rev. 07/16
Mag Cleaning
1. Clean the outside of the magazine with a soft cloth
moistened with clean water. Do not use chemicals on
the magazine.
2. Make sure the spring mechanism is NOT compressed.
3. The magazine has a removable lower half. To remove
the lower half, remove the lower screw; this allows
the ball piston and spring assembly to be removed as
shown at right.
4. The remaining magazine assembly may be
disassembled if desired. Refer to instructions below.
5. To reassemble do these steps in reverse. Place the
spring and ball piston into magazine first, then assemble
the lower panel back into place. Secure with the screw removed in step 3.
Magazine Disassembly
Follow these instructions to disassemble and reassemble the real magazine.
1. Remove the lower screw and cover as
described in step 3 above.
2. Remove the remaining screw from the
Magazine.
3. Lift the cover off of the Magazine.
4. Inspect and clean the parts inside the
Magazine.
5. Replace any damaged or worn out parts.
6. During reassembly, make sure the
Ball Catch is oriented properly. If not,
paintballs will not feed into the marker.
7. Replace the upper Magazine half, securing with the screw.
8. Place the spring and ball piston into magazine first, then assemble the lower panel back
into place. Secure with the screw.
Magazine Lubrication
There is a small hole by the magazine detent latch located on
the magazine. A single drop of oil will ensure spring does not
corrode. This spring is plated, but if left wet it could corrode, so
we recommend a small application of single oil drop every 25
uses.
The spring wind up cord, ball piston, and ratchet wheel is an
assembly. We do not recommend disassembly of these parts.
Note that the spring is a 3 stage progressive spring to ensure
even pressure and controlled tension as the ball stack releases,
as it moves around the magazine ball channel.
d
etent
