TINY TNC-G10, Operation Manual, Page: 11 / 18

11
Operation when sensors are disabled:
Press Ok in Home screen and enter in Setup menu. Disable M_SENSOR in Setup
mode. This operation is chosen if limits are to be set by user manually. Follow these
steps to set the manual limits:

Press Ok in the Home screen and enter in Setup menu.

Disable the M_SENSOR in Setup menu and press Ok to save it.

Set the Y-FEED DIR as left/ right as per requirement. Y-FEED DIR sets motor2 to
move left or right when being operated.

Press Esc key in Home screen to enter in Jog menu.

Press Key 0 to set the coordinates for motor1 and motor2 as zero coordinates.
Screen shot when the Zero Coordinates are made

Press Ok key to edit and set the desired limits using numeric keys. Press Ok key to
save these values and Esc key to discard the value.
Here are discussed all the modes in manual limit settings operation:
MODE 1: Press key 1 to select the mode1 and key 4 to set stop or continuous in
Home screen. The pattern for Mode 1 is shown below.
Screen shot when the Mode 1 is selected