Tinkerine Studio DittoPro-R, Setup & Operation Manual

Page: 12 / 19

11
Print Adhesion
Important!
Ensuring Proper Print Adhesion
Whenever you begin a print, always check that the first layer of the print is properly stuck onto the blue painter’s tape. A properly levelled print
surface should have the extruded filament a bit squished. While the printer is printing the skirt (outer perimeter), observe the deposited filament
and make micro-adjustments with the thumbscrew if necessary.
Signs of nozzle too close to print surface:
(A) Inconsistent width along extrusion.
(B) Portion of the layer appear thin or
non-existent.
(C) Squshed filament causes areas to
overfill.
Signs of nozzle levelled to print surface:
(A) Consistent width along extrusion.
(B) Thickness appears consistent across
entire layer.
(C) Infill is even and joins up neatly with
the perimeter.
Signs of nozzle too far to print surface:
(A) Filament appear stringy and doesn’t
adhere to print surface.
(B) Infill doesn’t meet up with perimeter.
(C) Infill line doesn’t stick to other infill
lines.
TOO CLOSE TOO FAR LEVELLED