TLR401 Administration
16
5.2.2 Write Template onto iCLASS Card (TLR401-iCLASS only)
Setting the reader to 'Template on Card' is required for this operation (see "Choose
iCLASS Mode", page 19) and the reader must 'know' the encryption of your iCLASS cards.
The 'Template on Card' mode does not store fingerprint templates to the TLR401 but
writes them onto iCLASS cards instead. The reader identifies authorized users by
comparing the fingerprint templates stored on the card with the scanned finger of the card
holder. If the two match the reader will send the facility code and card number to the
controller.
'Template on Card' may be expedient where storing biometric data is prohibited. In
addition this mode offers a good alternative using biometric readers in a Wiegand
configuration as users will not have to enroll on multiple readers.
At this point 'Template on Card' only works with 16K2 iCLASS cards and in a Wiegand
configuration.
The TLR401-iCLASS will store the fingers of a new user onto iCLASS cards when entering
the following on the keypad:
Admin
Mode
#
99
#
Green
1+2
Default Admin Code
1234
or enter your Admin Code
xxxx
#
Green
1+2+3
Enter
Enrollment
Code
16
#
Green
1
flashing
Sensor
Red
Apply 2 Fingers 3x
if successful:
Green 1+2+3+4 flashing
Apply Card
until the writing process is completed
Green 1 flashing Sensor Red
Enroll next finger or
Finalize
by
3
x
#
###
or wait for Timeout
