Micro Lynx ACG Option Card
ECC NO. 1019
Page 5
73630 REV. C
PROCEDURE (continued):
System Unit Serial Numbers 1068-1953
Install the ACG Option Card Bracket
5. Remove the “L” shaped bracket supporting the Back Panel PCB. Relocate this bracket
to the left side of the chassis as shown in Detail A and secure using the phillips screw
supplied in the ACG Option Installation Kit. (See Figure 5.)
Figure 5. Relocation of "L" Bracket
6. Remove the M3 Card, if installed. Remove the nut on the left threaded stud securing
the front panel to the chassis.
7. Hold the ACG Option Card bracket diagonally across the chassis with the cable
opening to the front. Set the front of the bracket in place on the threaded stud, inside
the chassis. Slide the bracket under the left edge of the Back Panel PCB and the VITC
Card (if installed).
8. Insert and tighten the screw removed from the back panel, and from the Back Panel
PCB. Replace the nut on the front panel threaded stud to secure the bracket. (See Figure
6.)
Figure 6. Install the ACG Option Card Bracket
