UK Timecode Systems Ltd. Unit 6, Elgar Business Centre, Moseley Road, Hallow, Worcester.
WR26NJ. UK
ISED Canada
ISED Canada (English)
This radio transmitter has been approved by Industry Canada to operate with its embedded
antenna. Other antenna types are strictly prohibited for use with this device. This device complies
with Industry Canada’s license
-exempt RSS standards. Operation is subject to the following two
conditions:
1. This device may not cause interference; and
2. This device must accept any interference, including interference that may cause undesired
operation of the device.
RF Exposure Statement
AirGlu2
™
module meets the given requirements when the minimum separation distance to human
body is more than 20cm. RF exposure or SAR evaluation is not required when the separation
distance is 20cm or more. AirGlu2
™
module has been tested for worst case RF exposure.
OEM Responsibilities to comply with IC Regulations
The transmitter module must not be co-located or operating in conjunction with any other antenna
or transmitter. Radiated emission must be tested with each new host product and ISEDC must be
notified with a Class 4 Permissive Change. OEM integrator is responsible for testing their end-
product for any additional compliance requirements required with this module installed (for
example, digital device emissions, PC peripheral requirements, etc.).
Important note
In the event that these conditions cannot be met (for certain configurations or co-location with
another transmitter), then the IC authorization is no longer considered valid and the IC ID cannot be
used on the final product. In these circumstances, the OEM integrator will be responsible for re-
evaluating the end product (including the transmitter) and obtaining a separate IC authorization.
End Product Labelling
The AirGlu
™
module is not labelled with IC ID because of its small physical size. The final end product
must be labelled in a visible area with the following:
“Contains Transmitter Module IC:
10427A-AGLU02
”
Or
“Contains IC:
10427A-AGLU02
”
The OEM integrator has to be aware not to provide information to the end user regarding how to
install or remove this RF module or change RF related parameters in the user manual of the end
product.
ISED Canada (Français)
