UK Timecode Systems Ltd. Unit 6, Elgar Business Centre, Moseley Road, Hallow, Worcester.
WR26NJ. UK
FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
• This device may not cause harmful interference, and
• This device must accept any interference received, including interference that may cause
undesirable operation.
Any changes or modifications not expressly approved by Timecod
e Systems could void the user’s
authority to operate the equipment.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. End users must follow the specific operating instructions for satisfying RF exposure
compliance. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter except in accordance with FCC multi-transmitter product procedures. OEM
Responsibilities to comply with FCC Regulations: The transmitter module must not be co-located or
operating in conjunction with any other antenna or transmitter except in accordance with FCC multi-
transmitter product procedures. Each new host will require reassessment of radiated spurious
emissions and a permissive change to the certification. For AirGlu2
™
module the minimum
separation distance to human body is 20cm. OEM integrator is responsible for testing their end-
product for any additional compliance requirements required with this module installed (for
example, digital device emissions, PC peripheral requirements, etc.). Important Note: In the event
that this condition cannot be met (for certain configurations or co-location with another
transmitter), then the FCC authorization is no longer considered valid and the FCC ID cannot be used
on the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating
the end product (including the transmitter) and obtaining a separate FCC authorization.
End Product Labeling
The AirGlu
™
module not labelled with its own FCC ID due to its physical size. If the FCC ID is not
visible when the module is installed inside another device, then the outside of the device into which
the module is installed must also display a label referring to the enclosed module. In that case, the
final end product must be labeled in a visible area with the following:
"Contains Transmitter Module FCC ID: AYV-AGLU02"
Or
"Contains FCC ID: AYV-AGLU02"
The OEM integrator must not provide information to the end user regarding how to install or
remove this RF module or change RF related parameters in the user manual of the end product.
