6
Possible Cause/Solution
1. Light switch is turned off.
2. Check Light bulb, it may
be loose or burned out.
3. Photocell determines it is
daylight.
Move away from light source.
4. Hand Held Transmitter is
too far from Receiver.
Move closer.
1. Receiver is in Manual
Override mode.
Flip wall switch off then on
again within 2 seconds to
place back in Auto Mode.
1. Hand Held Transmitter is
too far from Receiver.
Move closer.
Problem
• Light will not activate
when button is pressed.
• Light Stays on at night.
• Beam/light activates and
de-activates irregularly
when button is pressed.
Power Supply:
Environmental Protection:
Transmission Range:
Conforms to Directive:
1 x 3V CR 2032 lithium
battery
Suitable for use in dry
conditions only
Up to 100m (varies with
surrounding structures)
89/336/EEC
Troubleshooting guide
Technical specifications
iTLTK2_Instructions.qxd 28/4/06 3:57 pm Page 7
