4
Programming
To be operated by the Remote Light Control, the
Timeguard Wireless Receivers must learn the
Transmitters unique code. This programme is
achieved automatically by the following procedure.
1. Press the Rx units PROGRAM button for 1 to 2
seconds while Rx unit is powered. Be careful not to
hold any longer than 2 seconds or you may erase
all existing memorised codes. The light will go ON
indicating it is in PROGRAM MODE and will
remain on up to 5 minutes. (If programming a
Chime Receiver it will make a “beep” and the LED
will flash indicating it is program mode)
2. Press the Remote Light Control`s ON (1) button
to send its coded signal to the intended receiver.
(Its LED will light for 1 second). Transmitter will
send its coded signal to the Receiver and the light
will go off. (if using a Chime receiver a “beep” will
sound indicating it has been coded with the sensors
signal).
E
For optimum range hold
transmitter as shown.
Point this end of the
transmitter towards
target monitor
iTLTK2_Instructions.qxd 28/4/06 3:57 pm Page 4
