Timberwolf TW 280FTR (Petrol), Instruction Manual

Page: 30 / 68

4.7 Checks Before Starting
The following check list should be carried out daily, before starting the chipper and
whenever the chipper is moved to a new location.
1. ENSURE the chipper is located on firm, level ground.
2. ENSURE the chipper is well supported and cannot move.
3. ENSURE all guards are securely fitted.
4. ENSURE the discharge tube is in place, fastened securely and pointing in a safe
direction. (Refer to Section 4.4 " Discharge Controls" on page 25.)
5. ENSURE there are no objects in the feed funnel.
6. ENSURE the feed tray is in the up position to prevent people reaching the rollers.
7. CHECK for any visible signs of fluid leaks.
8. CHECK fuel and hydraulic levels are correct. (Refer to Section 4.16 " Check Hydraulic
Oil Level" on page 32, and Section 4.18 "Check Fuel Level and Refuel" on page 33.)
4.8 Starting the Engine
Do not engage the starter motor for more than 20 seconds. Allow a minimum of one
minute to elapse before attempting to start again.
1. The control circuit configuration ensures that the
engine always starts at idle.
2. Insert the ignition key in the control panel and turn to
position 1.
3. Confirm that the MIL illuminates continuously.
4. Turn the ignition key to the start position (2).
5. Release the ignition key as soon as the engine
starts.
6. Confirm that the MIL goes out.
Figure 13 - Control Panel
28/66 C190-0308 - Rev 1.0 EN
TW 280FTR (Petrol) 4 Operating Instructions