Timberwolf TW 230HB (Diesel), Instruction Manual

Page: 49 / 62

C190-0302 - Rev 1.0 EN 47/59
6.15 Grease the Roller Splines and Rotor Bearings
Carry out regularly. In dirty or dusty conditions, or during periods of hard work, at least
daily. If the bearings and splines are allowed to run dry, premature wear will occur,
resulting in a breakdown and the need for replacement parts. A failure caused by lack
of greasing is not covered by warranty. Early signs of insufficient grease include
squeaking, or knocking rollers.
DO NOT USE GRAPHITE BASED GREASE.
Figure 28 - Greasing Panel
It is recommended to grease all the nipples whilst the
engine is running and the rollers are turning. This will
ensure the grease is evenly distributed.
1. Locate the greasing panel (Figure 28).
2. Apply 4+ pumps of grease to each nipple.
3. The front and rear bearings are greased by nipples 'a'
and 'b'.
4. The top and bottom roller splines are greased by
nipples 'c' and 'd'.
6 Maintenance Instructions TW 230HB (Diesel)